Log in Register

Log in

Tech Centre Index

Tech Tips

Write a comment
Machinist's Workshop MagT recently published some information on various penetrating oils that I found very interesting.

Some of you might appreciate this. The magazine reports they tested penetrants for break out torque on rusted nuts.
They are below, as forwarded by an ex-student and professional machinist. They arranged a subjective test of all the popular penetrates with the control being the torque required to remove the nut from a "scientifically rusted" environment.

 *Penetrating oils ........... Average torque load to loosen*

No Oil used ................... 516 pounds
WD-40 ..................... ... 238 pounds
PB Blaster .................... 214 pounds
Liquid Wrench ...............127 pounds
Kano Kroil .................... 106 pounds
ATF*-Acetone mix............53 pounds

The ATF-Acetone mix is a "home brew" mix of 50 - 50 automatic transmission fluid and acetone. Note this "home brew" released bolts better than any commercial product in this one particular test.

Our local machinist group mixed up a batch and we all now use it with equally good results.
Note also that "Liquid Wrench" is almost as good as "Kroil" for about 20% of the price.

Steve from Godwin-Singer says that ATF-Acetone mix is best, but you can also use ATF and lacquer thinner in a 50-50 mix. *ATF=Automatic Transmission Fluid
This actually works well, power-steering fluid also works as well as trans fluid!{jcomments on}

Loading comment... The comment will be refreshed after 00:00.

Be the first to comment.

You must login to post a comment.
Text Size